Preparation of application surface

• it is a decorative construction gypsum product for aesthetic purposes such as carton Pierre, cornices, curtain board, column elements, ceiling floor etc.
• The application surface must be cleaned of dust and substances preveting adherence prior to

application.
• Special grain-size distribution yields hard and smooth cast surfaces.
• It is suitable for mould production in ceramic industry.
• It could easily be applied where construction plaster is applied.

Preparation of the mortar

• The mortar must be prepared in a clean container with smooth surfaces. The container must be free of any remains of previous applications.
• 7.0 lt. water added to 10 kg. TTR.
• Put water firstly in a clean container then sprinkle TTR until it covers the water surface.
• Wait a few minutes for submerging of surface plaster and mix with a plastering trowel or mechanical mixer working at low speed until a homogeneous mixture is achieved.
• Do not add any water or plaster to the mortar after mixing. Otherwise lumps appear in the mix.
• The mortar can be used for approximately 30 minutes.

• The mould should be olied to ensure easy removal of the product out of the mould(use only release agent).
• Reinforcement could be increased by hemp or synthetic fiber during carton Pierre casting.
• The product must be kept at ambient temprature for complate drying in order to avoid any fracture or cracks during application.
• Do not add any water or plaster to the mortar after mixing.

Storage conditions

• Bags must be stored in dry places and should not be stacked in more than 18 layers.
• Direct contact with ground an moisture should be avoided.
• Use TTR with in 6 months after production date. Over-long storage may deteriorate the physical properties of it.